Well, I’ve written about this before. Crosses. The design below has been modified during the weaving process, mainly because of mathematical errors. Yep, no mathematician here! Then there was digging all of the yarns out, finding enough of the various colors to complete each section. Believe me, I have been counting square inches and weighing yarns to make sure there was enough to weave a stripe. Because blacks might look alike, when you weave different dyelots, there’s always a line of demarcation. That won’t be a problem with the stripes because each stripe can be a different dyelot.
The middle section is a totally different story
I needed more black that matched for the middle section. First, I looked at two different local yarn stores, but found nothing suitable. That means dyeing. And it’s been really cold. Now, I apologize for that statement to all of you who have had all the really cold and snowy weather for the last few weeks, but for North Texas, it’s been cold. 14 and 16 degrees at night is unusual for us. Highs in the 30s–maybe--is cold for us. And I had to clean the dyepots before doing the dyeing. 30 degrees! They were really in need of cleaning, but not as bad as the image suggests. Lots of reflection going on in the stainless steel sides. The actual dyeing was a relief; at least it involved fire!
These crosses were originally designed with each arm being 4 inches wide, with 2 inch posts. Not sure about the vocabulary here, so here’s an illustration. However, that design changed as I mapped things out so that they would fit on the width of the warp. The cross width is a little over 3 inches, but the other numbers are the same.
Frankly, after the holidays, house guests, it’s hard for me to get back into the swing of things, but the weaving is back, as is the hard weaving bench. I’m also trying to spend some time working on some 3-D pieces. Those are pure experimentation, so we’ll see if they ever see the light of day.