A problem

Ikat-board Yes, this picture probably looks a bit familiar, but I’m using it to ask for help. This is the right side of my board and ikat table. The left side is clamped to the edge of the table with no problems. The right side in this picture can’t be clamped because the distance from the edge of the table to the peg board is too great. All of the small boards you see here are braced against the peg board and another board on the right to hold it in place. It’s not working so well. The only remedy I can come up with is to drill holes in the table and the peg board and then use a screw/wing nut to hold everything in place. But I hate to drill a hole in the table. Any ideas? Anyone?

Leave a Reply

Your email address will not be published. Required fields are marked *